Service

Load Management in Newcastle

Dynamic load management measures whole-of-home consumption and adjusts charging in real time, often avoiding a costly supply upgrade.

  • Matched with Licensed NSW Electricians
  • AS/NZS 3000 Compliant
  • Certificate of Testing
  • Free, No-Obligation Enquiry
  • Newcastle & Hunter Service Area
  • Clean, Tidy Installations
Load Management carried out by Newcastle EV Charger Group

Why homeowners choose it

Built around how you actually charge

  • Avoids a supply upgrade

    Often saves thousands versus increasing your service capacity.

  • No nuisance tripping

    The charger backs off automatically instead of tripping the main.

  • Two EVs on one supply

    Available current is shared between chargers, not doubled.

  • Uses every spare amp

    Charging runs at the highest safe rate available at any moment.

What's included

What a typical quote covers

  • CT clamp on the incoming main
  • Charger set to your true supply limit
  • Real-time current limiting
  • Multi-charger load sharing
  • Verification under load at handover

Installation process

  1. 01

    Establish the supply limit

    The main switch rating sets the ceiling the system must respect.

  2. 02

    Install metering

    A CT clamp is fitted so the charger can see total household current.

  3. 03

    Configure and calibrate

    The charger's limit is set and tested against real household loads.

  4. 04

    Verify

    The home is loaded to confirm the charger throttles rather than trips.

Typical Newcastle setups

Common property patterns

Illustrative photos of the install styles described above — stock imagery, not verified job photos.

Example wall-mounted EV charger in an Australian garage
Example install style — wall charger in a garage near the switchboard
Example outdoor EV charging point at an Australian home at night
Example install style — weatherproof outdoor charging point
Example solar-integrated EV charging at a New South Wales home
Example install style — solar-aware charging at a New South Wales home
Example dedicated EV charging circuit in an upgraded switchboard
Example install style — dedicated RCBO-protected circuit in the board
Example of a home EV charger being commissioned by an electrician
Example install style — commissioning and testing before handover
Example close-up of a finished home EV charger installation
Example install style — neat cable routing and a clean finish

Typical scenarios

Common Newcastle property patterns

  • 63A single phase home with ducted air conditioning

    Load management removes the risk of summer evening trips.

  • Two EV household

    Both cars charge overnight with current shared dynamically.

  • Older service with limited capacity

    Charging fits inside the existing supply, no upgrade needed.

FAQs

Load Management questions

  • Does load management slow my charging down?

    Only when the house needs the current — overnight it typically runs at full rate.

  • Which chargers support it?

    Most quality chargers support it with a CT clamp or external meter; confirm compatibility first.

  • Is it a substitute for a switchboard upgrade?

    It solves capacity, not condition. An unsafe board still needs upgrading.

Electric car charging in the driveway of a contemporary Newcastle home at dusk

Request a quote for your install.

Tell us your car and where you park.

  • Free, no-obligation enquiry
  • Matched with licensed NSW electricians
  • Installed to AS/NZS 3000
  • Newcastle, Lake Macquarie & the Hunter
02 4092 9490